Revision History - Basler WOOD BURNING FIREPLACE Wood Burning Fireplace

Revision History

Doc. ID Number Date
DA00057001 14 Oct 2002
DA00057002 07 Jan 2003
DA00057003 25 Jul 2003
DA00057004 2 Dec 2004
DA00057005 18 Apr 2005
DA00057006 4 April 2006
DA00057007 20 Mar 2007
BASLER A500
k
DRAFT
Changes
Initial release covering series production cameras.
The A501 color camera was added to the series.
kc
The high and low byte information was added to the AOI stamp.
The AOI Stamp and Dynamic AOI register was renamed and is now
called the AOI Feature register.
Vibration, shock, and bump specifications were added.
FVAL high time in Figure 2-8 and Figure 2-9 was corrected.
Figure 2-5 and Table 2-6 were changed.
The flash trigger output schematics for open collector and high side
switch and explanation were added in Figure 2-4.
The explanation on exposure modes in section
The minimum AOI height in lines was changed to 2.
The responsivity of the sensor changed, and with it the explanation in
section 1.3 and the formulas in section 3.7.1.
A power supply recommendation was added to section 2.8.
Marked several values in Table
In section 5.3, added sensor horizontal and vertical position tolerances
referenced to the sides of the camera.
Added a Feedback section.
Updated Figure 2-5 and Figure 2-7 in section 2.3.
Corrected flash trigger modes in section
ger mode "Always high" is 0x03 and not 0x04).
Corrected Write Command and Data Format in section
of the data bytes have been inversed).
Corrected the address for Singapore in the "Contacting Basler Support"
section of the front matter.
Corrected a LED supply voltage for the low side switch in Figure 2-4.
Corrected the steps and added information about reset behavior in the
note box in section 4.2.9.
Corrected the tilt angle tolerance in Figure 5-3.
Added section 6.3 that describes what to do before calling tech support.
Updated Basler address in the U.S.A.
Added storage conditions in section 1.4.
Interchanged required pixel clocks between A504k/kc and A501k/kc in
section 2.5.2.
Replaced FlashOut signal by Integrate Enabled signal in all figures of
section 3.3.
Augmented explanations in sections
Replaced "ExSync signal" by "internal control signal" in section 3.3.4.
Made minor corrections and additions throughout the manual.
Integrated the A503k.
3.3 was improved.
1-1 as typical.
4.2.4.16 (the ID for the flash trig-
4.2.10
3.3.1 to 3.3.5.
(the order
i