Xircom POCKET ETHERNET ADAPTER III User Manual page 83

ODI D R M R P A R A M m R S
See the alphabetical listing of network
operating
systems in the
Softwclw
Setup
and
Instalkation section to determine whether your network uses
an OD1 driver.
The OD1 driver PE30DI.COM uses
its
default
settings
unless other
options are specified in the NET.CFG file. This file
is
supplied on the
Xircom Network Drivers diskette and must be present
in
the same
directory as the OD1 driver.
While the Xircom OD1 driver defaults to Ethernet frame type 802.2, the
NET.CFG file supplied on the Xircom diskette sets both 802.2 and 802.3.
Therefore the Xircom NET.CFG file
must
be used if your network frame
type is
802.3.
To
change
any parameters, use an
ASCII t e x t
editor to open and modify
the NET.CFG file and i n s e r t the appropriate keywords and
values
after
the line
LINK DRIVER PE30DI
Keyword
syntax
for NET.CFG is as follows (keywords are not
case
sensitive):
Keyword De!fa&
validsetdn$5
FRAME FZIWWET-802.2 ETHBRNET-I1
ETHERNET-802.2
ETHERNET-802.3
ETHERNET-SNAP
"
AUTO
LPT
AUTO
(1 t o 3)
INT AUTO
( 3 to 15)
IOADMCESS
AUTO
(240
to 380)
LINKDISABLE LINK
INTEGRITY
ENABLED
72