Aerror Messages - Xircom POCKET ETHERNET ADAPTER III User Manual

APPENDIX
A
ERROR MESSAGES
The Xircom network drivers report the following problems if they occur
during the initialization of a network session. For error messages related
to network operation, see your network operating system documenta-
tion.
A Pocket Ethernet Adapter
could
not be found
Ensure that
AC
power connections are secure (whether from a wall
outlet or through the Phantom Power Cable) and that the power
cable
is
connected properly to the power input socket on the rear of
the Pocket Ethernet Adapter
III.
Ensure that the Pocket Ethernet Adapter 1 1 1
is
securely connected to
the parallel port (LPT1, LPT2, LPT3) specified during installation.
You may have specified a nonexistent parallel port during installa-
tion, or a Pocket Ethernet Adapter III device driver
is
already loaded.
Repeat the installation procedure.
pocLetEthemetAdapterIIIlddnssEEPROMann?dabk
The Pocket Ethernet Adapter
III
had an internal failure. Run the self
test
program described in the section on Configurarion andDiagm-
cics before calling Xircom Technical Support.
The Pocket
LAN
Adapter
hardware
connected to the parallel port
is
not compatible with the t y p e of driver software being used.
TheselestedIntermptislulavawle
TheselestedUO
address
is Mavlilable
The selected
LPT Port is atllvailable
These messages indicate that values for the parameters listed have
been changed in the NET.CFG or PROTOC0L.INI file, or on the
command line with packet, Artisoft, or DEC
PCSA
drivers, and that
the system cannot implement the changes.
Pocket
wemet
Adopter 111
User's
W e
61