Diagnostic Self Test; Executing The Self Test - Xircom POCKET ETHERNET ADAPTER III User Manual

DIAGNOSTIC SELF TEST
In addition to the diagnostic and power-on indicators
described
at the
beginning of this section, Xircom provides a self test diagnostics program
called PJi3"EST. This program, located on the Network Drivers diskette,
tests the Pocket Ethernet Adapter III configuration, setup, checksum, and
memory. It also reports t e s t results, the
serial
number of the unit, and the
node nddress.
EXECUTING THE SELF TEST
Use the following steps to execute the self test.
1.
I n s t a l l
the Pocket Ethernet Adapter
III
hardware according to the
iristructions contained in the InskaUation
and Setup
section of this
U s e r ' s Guide.
2. Boot your computer from DOS, without loading a network driver.
A network driver
must
n o t be loaded
for PE3TEST to run.
3.
Insert
the Xircom Network Drivers diskette in the diskette drive
on your computer and
change
to that drive.
4. At the diskette drive DOS prompt run
the diagnostics by typing
PE3TEST and then p i n g Enter.