Xircom POCKET ETHERNET ADAPTER III User Manual page 58

If for any reason you have to reboot at
t h i s point, you will receive
messages indicating that you do not have a 3Com EtherLink
adapter installed. Press Enter to override these messages arid
continue with the steps below.
2. Open an OS/2 box and use an ASCII t e x t editor to modify the
CONFIGSYS file. Replace the 3Com EtherLink driver name with
the Pocket Ethemet Adapter III driver name, as follows:
Change the line
DEVICE
=
\CMLIB\EMlWC.OS2
to read
DEVICE
=
\CMLIB\PE3NDIS.OS2
3.
Save the fde.
4.
Change to the
\cMLIB d i r e c t o r y .
5. Use
an ASCII text editor to open and edit the PROTOC0L.INI file
as follows:
In the [ETHERAND] section, modify the BINDINGS statement so
that it reads
BINDINGS
=
XIRCOMNET
At
the end of the PROTOC0L.INI file, add the following lines:
[
XIRCOMNET
]
D R I v m R A m
= XIRCoM$
6.
Save the fie.
7.
Copy the file PE3NDIS.OS2 from the \NDIS
d i r e c t o r y on the
Xircom Network Drivers diskette to the \CMLIB d i r e c t o r y on your
hard
disk.
8. Shut down OS/2.
9.
Reboot the PC.
47