Software Setup And Operation; 3Com 3 4 P E N - Xircom POCKET ETHERNET ADAPTER III User Manual

SOWARE SETUP AND OPERATI O N
This section provides installation information for the network drivers
supplied on the Pocket Ethernet Adapter
1 1 1
Network Drivers diskette. It
is
organized in alphabetical order by network operating System.
These
instructions are
designed to take advantage of the Pocket Ethernet
Adapter's self-configuring and default features. For more detailed
information on the drivers, see Appendix C, Command
Line
Parameten.
Why
a
Badnrp Copy
of
the
S o h
Before beginning driver installation, use DOS DISKCOPY to make a copy
of the Network Drivers diskette supplied with your Pocket Ethernet
Adapter III. Use the copy to install the software.
3COM M P E N
36m 3+Open
versions
1 s
for
DOS (NDlS
driver)
1.
Install your 3+0pen workstation software according to the
manufacturer's instructions, selecting the EtherLink II3C503
adapter. After completing the installation, and before rebooting
your system, continue with the following instructions.
Xircom Network Drivers diskette to the
directory
\30PEN\DOSWKSTA\LA"\DRIVERS on your hard disk or
boot diskette.
3. Using an
ASCII
text editor, replace the reference to the EtherLink
1 1
3C503 device driver in your CONFIG.SYS file with a reference
to the Xircom device driver, as follows:
2. Copy the file PE3NDIS.EXE from the \NDIS directory on the
Change the line
to read
4. Change to the \3OPEN\DOSWK!3TA\LA"\DRIVERS
directory.
W e t Ethernet
Adapter 111 User's
Guide
25