Rf Features; Automatic Configuration Update; Rf Address Stamping; Source Radio Address Delimiter Character - Datalogic Gryphom 4500 Series Product Reference Manual

RF FEATURES

Automatic Configuration Update

When this feature is enabled, the base station and reader will keep their configurations
synchronized. If a reader's configuration is altered by reading programming labels, this
change is automatically transferred and updated in a linked base station. Likewise, if the
base station's configuration is changed using Aladdin or by host commands, then the
reader's configuration will automatically be updated if this feature is enabled.

RF Address Stamping

Source Radio Address Delimiter Character

This option specifies the delimiter character to be placed between the label data and
radio address when address stamping is enabled.
Follow these instructions to select the delimiter character:
1. Determine the desired character, then find its hexadecimal equivalent on the ASCII
2. Scan the ENTER/EXIT PROGRAMMING MODE bar code to enter Programming
3. Scan the bar code: SET SOURCE RADIO ADDRESS DELIMITER CHARACTER.
4. Scan the appropriate two digits from the keypad in
5. Scan the ENTER/EXIT PROGRAMMING MODE bar code to exit.
Table 22 Source Radio Address Delimiter Character Setting Examples
STEP
1 Desired Setting
2 Scan ENTER/EXIT PROGRAMMING MODE
3 Scan SET SOURCE RADIO ADDRESS DELIMiTER CHARACTER
Scan Two Characters From
4
Appendix D
5 Scan ENTER/EXIT PROGRAMMING MODE
NOTE: This feature only applies if " Source Radio Address Transmission" on
page 251 is enabled
Chart on . A setting of 00 specifies no delimiter character.
page 341
Mode.
hexadecimal characters which were determined in the steps above. You will hear a
two-beep indication after the last character.
NOTE: If you make a mistake before the last character, scan the CANCEL
bar code to abort and not save the entry string. You can then start again at
the beginning.
ACTION EXAMPLES
No delimiter
, (comma)
character
'0' and '0' '2' and 'C'
RF FEATURES
, that represent the
Appendix D
- (dash)
/ (slash)
'2' and 'D' '2' AND 'F'
PRODUCT REFERENCE GUIDE
291