Bearing Carrier Installation - Polaris 2011 RANGER RZR Service Manual

FINAL DRIVE

Bearing Carrier Installation

1. Install drive shaft axle through the backside of the bearing
carrier. Be sure bushings and pivot tubes are installed.
2. Install the fasteners that attach the rear bearing carrier to the
upper and lower A-arms. Torque bolts to specification.
Upper Rear Bearing Carrier Bolts:
RZR: 33 ft. lbs. (45 Nm)
RZR S / RZR 4: 40 ft. lbs. (54 Nm)
Lower Rear Bearing Carrier Bolts:
RZR: 38 ft. lbs. (52 Nm)
RZR S / RZR 4: 40 ft. lbs. (54 Nm)
3. Apply grease to drive shaft axle splines.
7.28
= T
= T
9923142 - 2011 RANGER RZR / RZR S / RZR 4 Service Manual
© Copyright 2010 Polaris Sales Inc.
4. Install rear wheel hub assembly, cone washers, and hand
tighten the castle nut. Install washers with domed side out.
Cone Washers
Wheel
Hub
5. Install brake caliper mounting bolts and torque to 18 ft. lbs.
(24 Nm).
Rear Caliper Mounting Bolts:
18 ft. lbs. (24 Nm)
New bolts have a pre-applied locking agent
which is destroyed upon removal. Always use
new brake caliper mounting bolts
upon assembly.
Out
18 ft. lbs.
24 (Nm)
= T
CAUTION