Polaris 2011 RANGER RZR Service Manual page 338

Pad Inspection
1. Measure the thickness of the pad material. Replace pads if
worn beyond the service limit.
Front Brake Pad Thickness:
RZR/RZR S: .300" ± .007" (7.6 mm ± .178 mm)
RZR 4: .297 ± .007" (7.5 ± .178 mm)
Service Limit: .180" (4.6 mm)
Measure
Thickness
9923142 - 2011 RANGER RZR / RZR S / RZR 4 Service Manual
© Copyright 2010 Polaris Sales Inc.
Pad Assembly / Installation
1. Lubricate mounting bracket pins with a light film of
silicone grease and install rubber dust boots.
Apply Grease to Each
Bracket Pin
2. Compress mounting bracket and make sure dust boots are
fully seated. Install pads with friction material facing each
other.
WARNING
If brake pads are contaminated with grease, oil,
or liquid soaked do not use the pads.
Use only new, clean pads.
3. Install caliper onto front hub and torque mounting bolts to
specification.
RZR 4
Shown
Front Caliper Mount Bolt Torque:
31-34 ft. lbs. (42-46 Nm)
BRAKES
31-34 ft. lbs.
(42-46 Nm)
= T
9.9
9