Bearing Carrier Installation - Polaris 2011 RANGER RZR Service Manual

FINAL DRIVE
Bearing Installation
5. Thoroughly clean the front bearing carrier housing and the
outer race on the new bearing. Be sure that all oil residue
has been removed from each surface.
6. Support the bottom of the bearing carrier housing.
Use an arbor and press only on the outer race,
otherwise bearing damage may occur.
7. Apply Loctite® 603™ retaining compound to the outer
circumference of the new bearing race and carefully press
the new bearing into the bearing carrier housing.
Apply
Loctite® 603™
Snap Ring
RZR / RZR S
Shown
NOTE: Use care to not allow any of the Loctite®
compound to get in the bearing.
8. Wipe the housing clean of any excess compound and install
the snap ring.

Bearing Carrier Installation

1. Install drive shaft axle through the backside of the bearing
carrier.
2. Install the upper and lower ball joint ends into the front
bearing carrier.
RZR / RZR S
Shown
7.4
CAUTION
Bearing
9923142 - 2011 RANGER RZR / RZR S / RZR 4 Service Manual
© Copyright 2010 Polaris Sales Inc.
3. Install pinch bolts and torque to specification.
23 ft. lbs.
(31 Nm)
RZR / RZR S
Shown
23 ft. lbs.
(31 Nm)
RZR 4
Shown
Ball Joint Pinch Bolts:
23 ft. lbs. (31 Nm)
4. Apply grease to drive shaft axle splines.
5. Install front wheel hub assembly, cone washers, and hand
tighten the castle nut. Install washers with domed side out.
Cone Washers
Wheel
Hub
6. Install brake caliper mounting bolts and torque to
specification.
= T
Out