Ignition Key Switch (INT'L)
1.
Disconnect the key switch harness by lifting the connector
lock and pulling on the connector. Do not pull on the
wiring.
2.
Test between the 4 sets of outputs (OFF / ON LIGHTS / ON
/ START). If any of the tests fail, replace ignition switch
assembly.
• Turn the ignition key to ON LIGHTS. There should be
continuity between switch pins A, E and F; C and D.
• Turn the ignition key to ON. There should be continuity
between pins C and D; E and F.
• Turn the ignition key to START. There should be
continuity between pins A and B; C and D; E and F.
9923142 - 2011 RANGER RZR / RZR S / RZR 4 Service Manual
© Copyright 2010 Polaris Sales Inc.
AWD / 2WD Switch
1.
Disconnect the AWD / 2WD switch harness by depressing
the connector locks and pulling on the connector. Do not
pull on the wiring.
2.
Test between the 2 sets of outputs (AWD / 2WD). If any of
the tests fail, replace the switch assembly.
• Move the switch to AWD (ON). There should be
continuity between switch pins 2 and 3.
• Move the switch to 2WD (NONE / OFF). There should
be no continuity between any pins.
ELECTRICAL
10
10.5