Special Tools; Torque Specifications; Front Bearing Carrier; Bearing Carrier Inspection / Removal - Polaris 2011 RANGER RZR Service Manual

FINAL DRIVE

SPECIAL TOOLS

PART NUMBER
2872608
8700226
PU-48951

TORQUE SPECIFICATIONS

Wheel and Hub Torque Table
ITEM NUT TYPE
Aluminum Wheels Lug Nut
(Cast) (1)
Steel Wheels Flange Nut
(Black / Camo) (2)
Front Hub
Castle Nut
Rear Hub
Castle Nut
#1
Aluminum Wheel
(LE Models)
30 ft. lbs. + 90° (1/4 turn)
7.2
TOOL DESCRIPTION
Roll Pin Removal Tool
CV Boot Clamp Pliers
(earless type)
Axle Boot Clamp Tool
SPECIFICATION
30 ft. lbs. + 90° (1/4 turn)
27 ft. lbs. (37 Nm)
- 80 ft. lbs. (108 Nm)
- 80 ft. lbs. (108 Nm)
Steel Wheel
(Standard Models)
27 ft. lbs. (37 Nm)
9923142 - 2011 RANGER RZR / RZR S / RZR 4 Service Manual
© Copyright 2010 Polaris Sales Inc.

FRONT BEARING CARRIER

Bearing Carrier Inspection / Removal

1. Elevate front of vehicle and safely support machine under
the frame area.
Serious injury may result if machine tips or falls.
Be sure machine is secure before beginning this
service procedure. Wear eye protection when
removing bearings and seals.
2. Check bearings for side play by grasping the top and bottom
of the tire firmly and checking for movement. The tire
should rotate smoothly without binding or rough spots.
#2
3. Remove the (4) wheel nuts and remove the front wheel.
4. Remove the cotter pin and loosen the front wheel hub castle
nut. Remove the nut, and (2) cone washers from the front
wheel hub assembly.
Cone
Washers
5. Remove the fastener retaining the steering tie rod end to the
front bearing carrier.
CAUTION
Castle Nut
Cotter Pin