Polaris 2011 RANGER RZR Service Manual page 249

CLUTCHING
4. With the snap ring (A) removed and spring pressure
relieved, remove the outer spring retainer (B), compression
spring (C), spacer (D), and inner spring retainer (E).
E
C
C
D
5. Separate the two clutch sheaves.
6. Inspect the helix on the moveable sheave.
Inspect for Abnormal Wear
6.22
D
B
A
B
E
9923142 - 2011 RANGER RZR / RZR S / RZR 4 Service Manual
© Copyright 2010 Polaris Sales Inc.
7. Remove the inner spring retainer from the inner sheave.
Inspect for wear and replace as needed.
Inspect for Abnormal Wear
8. Check the rollers in the stationary sheave for wear. If rollers
are worn, a new driven clutch assembly may be needed.
Check Rollers for Wear
9. Inspect the bearings inside the moveable sheave.
Inspect Bearings for Wear
Moveable Sheave Bearing Inspection:
Replace the clutch assembly if more brass
than Teflon™ is visible on the bearing.