Efi Diagnostics; Instrument Cluster Trouble Code Display; Diagnostic Trouble Code Table - Polaris 2011 RANGER RZR Service Manual

ELECTRONIC FUEL INJECTION

EFI DIAGNOSTICS

Instrument Cluster Trouble Code Display

NOTE: The diagnostic mode is accessible only
when the check engine MIL has been activated.
Use the following procedure to display diagnostic trouble codes
that were activated during current ignition cycle causing the
MIL to illuminate. Diagnostic trouble codes will remain stored
in the gauge (even if MIL turns off) until the key is turned off.
NOTE: If there is a diagnostic problem with the
power steering system, the power steering MIL will
illuminate and blink in place of the check engine MIL.
1. If the trouble code(s) are not displayed, use the MODE
button to toggle until "CK ENG" displays on the
information display area.
2. Press and hold the MODE button to enter the diagnostics
code menu.
Component
Throttle Position Sensor (TPS)
Vehicle Speed Signal
Manifold Absolute Pressure Sensor
(T-MAP)
Intake Air Temperature (T-MAP)
Engine Temperature Sensor (ECT)
4.36

DIAGNOSTIC TROUBLE CODE TABLE

Condition
Voltage Too High
Voltage Too Low
Data Erratic or Intermittent (or missing)
Received Vehicle Speed Has Error
Voltage Too High
Voltage Too Low
Voltage Too High
Voltage Too Low
Voltage Too High
Voltage Too Low
Temperature Too High
Engine Overheat Shutdown
9923142 - 2011 RANGER RZR / RZR S / RZR 4 Service Manual
© Copyright 2010 Polaris Sales Inc.
3. A set of three numbers will appear in the information area.
• The first number (located far left) can range from 0 to 9.
This number represents the total number of trouble code
present (example: 2 means there are 3 codes present).
• The second number (located top right) can be 2 to 6
digits in length. This number equates to the suspected
area of fault (SPN).
• The third number (located bottom right) can be 1 to 2
digits in length. This number equates to the fault mode
(FMI).
4. If more than one code exists, press the MODE button to
advance to the next trouble code.
5. To exit the diagnostic mode, press and hold the MODE
button or turn the ignition key OFF once the codes are
recorded.
SPN
51
84
102
105
110
Digital Wrench™
FMI
P-Code
3 P0123
4 P0122
2 P0503
19 C1069
3 P0108
4 P0107
3 P0113
4 P0112
3 P0118
4 P0117
16 P0217
0 P1217