Collating Copies
The Finisher modes can be selected to collate the copies in various ways, either by
1
pages or copy sets.
■ The table below shows all the finishing modes that are available with each
different optional unit, and the paper sizes that can be used.
✔
: Available
—
: Unavailable
Optional Unit
*1 The copies are stapled at the part that represents the upper left corner of the original.
*2 The maximum when you are using 64 g/m 2 to 80 g/m 2 paper. If the number of sheets is greater than the limit,
they will not be stapled.
IMPORTANT
Pull out the output auxiliary tray when stapling paper larger than A4.
NOTE
If <AUTO COLLATE> is set to 'COLLATE' or 'STAPLE', the Collate (Offset Collate with
the optional Finisher-U1 attached) or Staple mode is automatically set when you place
the originals into in the feeder. (See "Auto Collate," on p. 3-15.)
1-42
Collating Copies
Collate
None
A3, A4, A4R, A5,
Finisher-U1
Inner 2 Way
A3, A4, A4R, A5,
Tray-E1
Offset
✔
A5R
—
A3, A4, A4R
✔
A5R
Staple*
—
—
✔
✔
A3, A4R
(30 sheets)*
(50 sheets)*
—
—
1
2
, A4
2