GATEWAY ADDR.
255 . 255 . 000 . 000
GATEWAY ADDR.
255 . 255 . 255 . 255
W 736 mm
SETUP SHEET
ROLL
Step 3: Make the Port Settings for the Software RIP
Make the settings for the software RIP. For the output destination, use the setting for the IP address
made on the printer. For information about how to make the settings, refer to the documentation for
the software RIP.
You can check whether the connection to the network has been made by using the printing-test feature
in the software RIP you're using. For information about how to carry out a printing test, refer to the
documentation for the software RIP.
Press
.
Repeat
and
numbers.
When you've finished making the setting, press
.
Press
.
Press
to go back to the original screen.
8. Network Settings
to set the gateway address
59