Roland LEC-300A Setup Manual page 52

6. Installing the Ink Cartridges (LEC-330)
2.
Clean the print heads using the SOL INK cleaning cartridge.

SELECT INK TYPE
ECO‑UV CMYKGlGl
ECO-UV gloss/gloss mode
SELECT INK TYPE
ECO‑UV CMYKWW
ECO-UV white/white mode
SELECT INK TYPE
ECO‑UV CMYKGlW
ECO-UV gloss/white mode
SELECT INK TYPE
ECO‑UVS CMYKWW
ECO-UVS ink mode

INSTALL

SET CL-LIQUID
FILLING INK...
>>

REMOVE CL-LIQUID
SET CL-LIQUID
FILLING INK...
>>>>
50
DRAIN BOTTLE
1 2 3 4
1 2 3 4
5 6
Check the selected ink mode.
<When the selected ink mode is enabled>
Press .
<When an incorrect ink mode is enabled>
Switch off the sub power.
Again carry out the procedure on page 47, "Selecting the Ink
Mode."
Make sure the drain bottle is installed.
Press .
Insert the SOL INK cleaning cartridges into slots
1, 2, 3, and 4.

Pull out the SOL INK cleaning cartridges.

Insert the SOL INK cleaning cartridges you pulled
out into slots 5 and 6.