Step 3: Make The Port Settings For The Software Rip - Roland VERSAUV LEC-300 Setup Manual

7. Network Settings

W 736 mm
SETUP SHEET
ROLL
If you're using one computer and one machine, this completes the settings to make on the printer. Go on to Step 3.
If setting the gateway address is required, then go on to the procedure following this one.
3.
Set the gateway address.

NETWORK
GATEWAY ADDR.

GATEWAY ADDR.
000 . 000 . 000 . 000

GATEWAY ADDR.
255 . 000 . 000 . 000

GATEWAY ADDR.
255 . 255 . 000 . 000

GATEWAY ADDR.
255 . 255 . 255 . 255

W 736 mm
SETUP SHEET
ROLL

Step 3: Make the Port Settings for the Software RIP

Make the settings for the software RIP. For the output destination, use the setting for the IP address made on the printer. For
information about how to make the settings, refer to the documentation for the software RIP.
You can check whether the connection to the network has been made by using the printing-test feature in the software RIP
you're using. For information about how to carry out a printing test, refer to the documentation for the software RIP.
46
Press .
Press to go back to the original screen.
1.

From the screen -
Press twice.
Use to select the address number.
[GATEWAY ADDR.] : 255.255.255.255
Note: For information about the value to enter for the gateway address, consult your
network administrator. Here, "255.255.255.255" is entered by way of example.
Press .


Repeat and to set the gateway address numbers.
When you've finished making the setting, press
Press .
Press to go back to the original screen.
, press twice.
.