Step 3: Make The Port Settings For The Software Rip - Roland VersaCamm VP-540i Setup Manual


If you're using one computer and one machine, go on to
3
on to .
3.
Set the gateway address.





4.
Finish making the settings.


Step 3: Make the Port Settings for the Software RIP

Here you set the output destination port for the software RIP. For the output destination, use the setting for the IP address
made on the machine. For information about how to make the settings, refer to the documentation for the software RIP.
You can check whether the connection to the network has been made by using the printing-test feature in the software RIP
you're using. For information about how to carry out a printing test, refer to the documentation for the software RIP.
 
Repeat and to set the subnet mask.
When you've finished making the setting, press
Press .
The screen shown in the figure appears again.
Press .
Press twice.
Use to select the address number.
[GATEWAY ADDR.]: 255.255.255.255
For the value to enter for the gateway address, consult your network administrator.
Here, "255.255.255.255" is entered by way of example.
Press .
 
Repeat and to set the gateway address numbers.
When you've finished making the setting, press
Press to go back to the original screen.
4
. If setting a gateway address is required, go
8. Network Settings
.
.
43