Step 3 : Make The Port Settings For The Software Rip - Roland SOLJET Pro III XC-540 Setup Manual

š
SUBNET MASK
255. 255. 255. 000
›
W 1346 mm
SET UP SHEET
ROLL
If you're using one computer and one machine, this completes the settings to make on the printer. Go on to Step 3.
If setting the gateway address is required, then go on to the procedure following this one.
3.
Set the gateway address.
–
NET WORK
GATEWAY ADDR.
—
GATEWAY ADDR.
000. 000. 000. 000
˜
GATEWAY ADDR.
255. 000. 000. 000
™
GATEWAY ADDR.
255. 255. 000. 000
š
GATEWAY ADDR.
255. 255. 255. 255
›
W 1346 mm
SET UP SHEET
ROLL

Step 3 : Make the Port Settings for the Software RIP

Make the settings for the software RIP. For the output destination, use the setting for the IP address made on the
machine. For information about how to make the settings, refer to the documentation for the software RIP.
You can check whether the connection to the network has been made by using the printing-test feature in the software
RIP you're using. For information about how to carry out a printing test, refer to the documentation for the software
RIP.
™ š
Repeat and to set the subnet mask.
When you've finished making the setting, press
Press .
Press to go back to the original screen.
œ
1.
From the screen - , press
Press twice.
Use to select the address number.
[IP ADDRESS] : 255.255.255.255
Note: For information about the value to enter for the gateway address, consult
your network administrator. Here, "255.255.255.255" is entered by way of ex-
ample.
Press .
™ š
Repeat and to set the gateway address numbers.
When you've finished making the setting, press
Press .
Press to go back to the original screen.
7. Network Settings
.
twice.
.
45