Network Adapter (10/100/1000); Problems With Data Transmission Via Lan/Ethernet; Figure 12.1: Rj45 Network Port - Advantech DLoG MTC 6 Series User Manual

12.4. Network adapter (10/100/1000)

The MTC 6 is equipped with a 10/100/1000 Mbit network adapter. This adapter can be
accessed via the bottom of the device and offers an RJ45 connection jack.
The RJ45 connection port features two integrated status LEDs. They display the
following messages:
Left LED (green)
LED off: not connected
LED on: connected

12.4.1. Problems with data transmission via LAN/Ethernet

If problems occur during data transmission over LAN/Ethernet (e.g. data is lost or not
detected), the cause of these problems may be a cable which is too long.
Depending on the cable layout and interference from the environment, it may be
impossible to use the cable length of 100 m given in the specification (IEEE 802.3
standard).
The solution here is the use of a shorter cable.
MTC 6 Series
RJ45 network port

Figure 12.1: RJ45 network port

User's Manual V2.00
Internal devices
Right LED (orange):
LED off: no activity
LED flashes: activity
75