Powering Up The Mtc 6; Figure 5.12: Mtc 6 <Power>-Key - Advantech DLoG MTC 6 Series User Manual

Initial operation

5.9. Powering up the MTC 6

Only power up the MTC 6 after connecting all of the devices.
The MTC 6 is powered up by connecting it to an appropriate power supply and then,
depending on the version of the device, either using the <Power>-key or the ignition
signal.
Make sure there is a suitable disconnecting device such as a power
NOTICE:
switch or circuit breaker in the power supply circuit.
Property
damage
<Power>-key
52
Figure 5.12: MTC 6 <Power>-key
User's Manual V2.00 MTC 6 Series