Advantech DLoG MTC 6 Series User Manual page 74

Mounting
Unfasten antenna cap from unit and refasten it:
1. Unscrew the two screws from the antenna cap with an Allen key (size 3 mm).
2. Lift the antenna cap carefully to avoid pulling on the antenna connection cables
(max. 2 to 3 cm).
3. Keep hold of the antenna cap, making sure that no pulling tension is exerted on the
antenna connection cables.
4. The Service USB interface is now accessible.
CAUTION: One end of the antenna connection cables is attached to the antenna
cap, the other end to the internal WLAN unit of the MTC 6. The cables must not be
pulled out of the MTC 6 too far and become detached from the WLAN unit! This
might damage the WLAN unit or other components of the device.
5. Place the antenna cap back onto the MTC 6.
6. Take care not to trap the antenna connection cables when doing this.
The antenna cap seal must not be damaged; it must be seated correctly in the
groove.
7. Reinsert and tighten the two screws of the antenna cap (1 Nm torque).
64 User's Manual V2.00 MTC 6 Series