imagistics C400 Operating Manual page 92

4
Using the Programming Mode
Chapter
Meter Count, Image Quality Cycle and Drum Dehumidifier
Meter Count
Touching Meter Count allows you to check the total count of each of the
following five counters.
Total Counter: Shows the total number of copies made since the installation of
the copier.
Size Counter: Shows the number of copies made on copy paper of a preset
size. (The size will be set by your Technical Representative.)
2-Sided Total: Shows the number of 2-sided copies.
2-Sided Size: Shows the number of copies made on copy paper of a pre set
size (the same size as set for Size Counter).
# of Active Accounts: Shows the number of copies made by the active
accounts.
Image Quality Cycle
Touching Image Quality Cycle sets the copier into the auxiliary toner
replenishing mode.
The copier tends to exhaust the supply of toner rapidly when making a number
of copies from an original with dark solid areas such as a photo. As a result, the
image density of the copy will become lighter. If this happens, use Image
Quality Cycle to regain the normal image density quickly
Notes:
• Do not turn OFF the Power Switch or open the Front Door while the copier is
replenishing toner.
• Toner is not replenished if the image density is sufficiently high.
• The toner replenishing sequence ends automatically.
Drum Dehumidifier
Touch Drum Dehumidifier to activate the Drum Dehumidifier function.
During times of high humidity or when there are sudden rapid changes in
humidity (especially when you are using a heater in winter),condensation can
form on the surface of the PC Drum,resulting in blotchy copies. In such
instances, use Drum Dehumidifier to dry the surface of the PC Drum.
83