Interrupt; Mode Check; Access Number - imagistics C400 Operating Manual

2
Overview
Chapter
Auxiliary Functions

Interrupt

The Interrupt function allow you to interrupt
a current job and run a different one.
Pressing the Interrupt key once sets the
copier into the copier leave the Interrupt
mode, returning to the previous settings.
Useful Tips
• If the current job involves 2-sided
copying, Cover function, Page Insertion
or Transparency Interleavings, the
copier rejects an Interrupt cycle.
•If the Current job involves a finishing
function other than Non-Sort, Non-Sort
is automatically selected at the same
time when Interrupt function is selected.

Mode Check

The Interrupt function allow you to interrupt
a current job and run a different one.
Pressing the Interrupt key once sets the
copier into the copier leave the Interrupt
mode, returning to the previous settings.
•When you touch EXIT after having checked
the currently set function set functions, the
Basic screen reappears.
•To change a certain function, touch the
corresponding key and then make the
necessary change.

Access Number

If an access number has been programmed,
it allows only particular persons to use the
or supervisor to keep track of the number of
copies make by a particular department
22
Notes:
•If an access number has been programmed, a
copy cycle can be initiated only after the
access number has been input to the copier.
<"Access #"Prompt Screen>
•Before you can use this function, you must
first turn "ON" the "Copy Track"function of the
Administrator Mode available from The Key
Operator function. p. 86
Entering the Access Number
1
From the 10-key Pad, entered the 4-digit
1
access number and press the Access
Mode Key.
1 2 3
4 5 6
7 8 9
0 C
Notes:
To correct the 4-digit access number entered,
first press the Clear key, then enter the new
number.
2
When the initial screen reappears, you can
2
now start a copy cycle.
3 When the copy cycle is completed, press
3
the Access Mode key again.
1134P438DA