Exiting And Saving; Procedure - Fujitsu DL 3750+ User Manual

EXITING AND SAVING

< < F U N C T I O N > >
SAVE&END MENU1
V-ALMNT
User's Manual
This section describes how to exit the setup mode save any changes you
made:
To exit setup mode immediately, select the SAVE & END function.
Any settings changed while in setup mode are saved as the new power-on
defaults for the printer. The new defaults remain active until you change them
again.
NOTE
The only way to exit setup mode without saving your changes is to turn
off the printer. When you turn the printer back on, the previous default
settings are used.

Procedure

To exit setup mode and save your changes using SAVE & END, proceed as
follows:
1. Print the <<FUNCTION>> menu.
The <<FUNCTION>> menu should be the last printed line on the
page. If the menu is not printed, press the ONLINE button to print
the menu. If you are using the SELF-TST or HEX-DUMP function,
press the LF/FF button instead of the ONLINE button to print the
menu. The <<FUNCTION>> menu is shown below.
MENU2 HARDWRE ADJUST
2. Select the SAVE & END function.
Make sure that the red cursor is positioned under SAVE & END.
Press the MENU button or the TEAR OFF button to select SAVE &
END. The printer exits setup mode and returns online (the ONLINE
indicator lights green). Any changes you made while in setup mode
are saved.
CONFIG DEFAULT LIST
USING SETUP MODE
SELF-TST HEX-DUMP
5-49