Fujitsu DL 3750+ User Manual page 122

USING SETUP MODE
5-42
Table 5.6 CONFIG Items and Options (Cont.)
NOTE: Underlined options are the factory defaults.
CONFIG Items Options
<TEARPOS>
VISIBLE
ALWAYS
The following <TEAR-EN> item is printed when TEAROFF:AUTO is
specified for the <TEAROFF> item.
<TEAR-EN>
0 SEC
1 SEC
2 SEC
4 SEC
6 SEC
Description
Tearoff position.
Select this option when your software
positions forms to the next top-of-
form after printing the last data. The
printer performs tearoff feed without
adding a form feed when data transfer
has stopped.
Select this option when your software
stops after printing the last data. The
printer performs tearoff feed after
adding a form feed when data transfer
has stopped.
Note: For both settings, tearoff
positioning will fail if the page
length setting does not match the
actual perforation spacing.
Tearoff enabled time (offset time).
The offset time is from when data
transfer stops to when the printer
performs automatic tearoff feed.
If the printer receives data again
within the offset time, the printer does
not perform automatic tearoff feed.
User's Manual