Starting Or Stopping Printing; Starting Printing; Stopping Printing; Resuming From A Paper-Out - Fujitsu DL 3750+ User Manual

STARTING OR STOPPING
PRINTING
User's Manual
3. Press the ONLINE button to return online. You are ready to print
using the selected menu.

Starting Printing

Before you start to print, make sure that paper is loaded. Also, verify that the
paper thickness lever is set to the appropriate position (1 to D).
To start printing, press the ONLINE button to place the printer online. Then
start your software.

Stopping Printing

To stop printing immediately, press the ONLINE button to place the printer
offline. You can also use your software to stop printing, but there will be a
slight delay before printing stops. Any data sent to the print buffer but not yet
printed is stored until you resume printing. Data in the print buffer is lost if
you turn the printer off.
To resume printing, press the ONLINE button again. To cancel printing, use
the cancel commands provided by your software or computer. To clear the
print buffer, place the printer offline and press the MENU and TEAR OFF
buttons. Any data sent to the print buffer before you canceled printing will be
lost.

Resuming from a Paper-Out

The printer can "sense" when paper runs out. Depending upon how PPR-
OUT (paper-out) is set in setup mode, the printer either:
• Stops printing and lights the red PAPER OUT indicator, or
• Continues printing until no more data remains in the printer.
See Chapter 5 for details on setting PPR-OUT. The factory default is to stop
printing if continuous forms paper runs out and to continue printing if single
sheet paper runs out.
To resume printing when paper runs out, use either of the methods described
below:
PRINTING
PRINTING
4-5