Table of Contents
Advertisement
User's Manual
To load paper in the cut sheet feeder:
1. Make sure that the printer is turned on and continuous forms are
retracted to the park position. (For details, see the section Unloading
Continuous Forms later in this chapter.)
2. If necessary, reset the paper thickness lever. (See the section Adjust-
ing for Paper Thickness earlier in this chapter.)
3. Move the paper select lever forward. (This lever is at the top left
corner of the printer.)
4. Prepare the feeder as follows:
Preparing the cut sheet feeder
• To open the paper bin, push the bin lever up to the "OPEN" position.
The bin lever is located on the left side or both sides of the feeder.
• Push back both of the paper guide locking levers on the feeder.
• Position the left paper guide. Pull the left locking lever forward to
secure the left paper guide.
PAPER HANDLING
3-9
Advertisement
Table of Contents
