Table of Contents
Advertisement
USB INTERFACE
User's Manual
Cable
This printer supports the USB 1.1 Full speed specification. To connect to the
host, use USB 2.0-compliant INF cables (5 meters (196 inch) or shorter).
(Use the shielded cables.)
Connector pin alignment
2
1
3
4
- Connector specification
Printer side
Cable side
Specification
- Basic specification
Note
It does not guarantee all operations on hosts.
- Power control
- Transmission mode
INTERFACE INFORMATION
No. Signal line name
Function
1
vbus
Power supply
2
D-
Data transfer
3
D+
Data transfer
4
GND
Signal ground
Shell
Shield
Type B receptacle (female)
Upstream port
Type B plug (male)
USB interface compliant
Self-power device
Full speed (Maximum 12 Mbps +
0.25%)
D-11
Advertisement
Table of Contents
