Procedure - Fujitsu DL 3750+ User Manual

<<FUNCTION>>
SAVE&END MENU1 MENU2 HARDWRE ADJUST CONFIG DEFAULT LIST SELF-TST HEX-DUMP
V-ALMNT
<PPR-OUT>
User's Manual

Procedure

To change the printer's hardware options, make sure that continuous forms
are loaded and then proceed as follows:
1. Enter setup mode.
Press the TEAR OFF button and the ONLINE button simultane-
ously until the printer beeps. Wait for the printer to stop printing
and check that the following <<FUNCTION>> menu is printed:
2. Select the HARDWRE function.
Repeatedly press the LOAD button or the LF/FF button to position
the red cursor under HARDWRE. Press the MENU button to select
the HARDWRE function and print the first item and its options, as
shown below:
CNTONLY DETECT
3. Select an option for the selected item.
Press the LOAD button or the LF/FF button to move the cursor to
the option you require. Press the MENU button to select the option
and print the next item.
NOTE
To print the previous item, press the TEAR OFF button.
4. Repeat step 3 until all required options are changed.
5. Exit the HARDWRE function.
Press the ONLINE button to exit the HARDWRE function and
reprint the <<FUNCTION>> menu.
IGNORE
USING SETUP MODE
5-35