Procedure - Fujitsu DL 3750+ User Manual

USING SETUP MODE
< < F U N C T I O N > >
SAVE&END MENU1
V-ALMNT
<EMULATE>
5-28

Procedure

To change the options assigned to MENU1 or MENU2, make sure that
continuous forms paper is loaded and then proceed as follows:
1. Enter setup mode.
Place the printer offline. Press the TEAR OFF button and the
ONLINE button simultaneously until the printer beeps. Wait for the
printer to stop printing. The following <<FUNCTION>> menu is
printed:
MENU2 HARDWRE ADJUST
2. Select the MENU1 or MENU2 function.
Repeatedly press the LOAD button or the LF/FF button to position
the red cursor under either the MENU1 or MENU2 function. Press
the TEAR OFF button or the MENU button to select the function
and print the following <EMULATE> options:
DPL24C+ XL24E
3. Select an emulation.
Repeatedly press the LOAD button or the LF/FF button to position
the cursor under the emulation you require. Then do either of the
following:
• Press the MENU button to select the emulation and print the next
MENU1 or MENU2 item. (As shown in Table 5.3, this is the
<FONT> item).
• Press the TEAR OFF button to select the emulation and print
<==END==>. Press the TEAR OFF button again to print the
last MENU1 or MENU2 item. (As shown in Table 5.3, this is
the <RGHTEND> item). The TEAR OFF button is convenient
when the options you need to change are near the end of the list of
items.
CONFIG DEFAULT LIST
ESC/P2
SELF-TST HEX-DUMP
User's Manual