Arabization Options; Exiting And Saving; Procedure (For Led Type) - Fujitsu Impact 4550 PRO User Manual

USING SETUP MODE
ARABIZATION
OPTIONS
EXITING AND
SAVING
<< FUNCTION >>
SAVE&END MENU1
HEX-DUMP V-ALMNT
5-64 User's Manual
The Arabization options are available in the ARAB1 and ARAB2 menus.
For more information on these two menus please refer to the Arabization
Guide.
This section describes how to exit setup mode and save any changes you
made:
To exit setup mode immediately, select the SAVE & END (for LED
type) SAVE&EXIT (for LCD type) function.
Any settings changed while in setup mode are saved as the new power-
on defaults for the printer. The new defaults remain active until you
change them again.
NOTE (LED only)
The only way to exit setup mode without saving your changes is to
turn off the printer. When you turn the printer back on, the previous
default settings are used.

Procedure (for LED type)

To exit setup mode and save your changes using SAVE/END, proceed as
follows:
1. Print the <<FUNCTION>> menu.
The <<FUNCTION>> menu should be the last printed line on
the page. If the menu is not printed, press the ONLINE button to
print the menu. The <<FUNCTION>> menu is shown below:
MENU2 HARDWRE ADJUST
INITIAL
2. Select the SAVE/END function.
Make sure that the cursor on the left edge of the aluminum print
guide is positioned under SAVE & END. Press the
the
mode and returns online (the ONLINE indicator lights green).
Any changes you made while in setup mode are saved.
CONFIG GAP-ADJ
button to select SAVE & END. The printer exits setup
USING SETUP MODE
DEFAULT LIST SELF-TST
button or
User's Manual 5-64