Table of Contents
Advertisement
USING SETUP MODE
5-38
Table 5.5 ADJUST Items and Options (Cont.)
NOTE: Underlined options are the factory defaults.
ADJUST
Items
<CNT-LFT>
–10/90, ..., 0/90,
..., 10/90
<CUT-LFT>
–10/90, ..., 0/90,
..., 10/90
<CUT-ADJ>
–21/360, –14/360,
–7/360, 0/360,
7/360, 14/360, 21/360,
GRAPHIC (*1)
<CSF-ADJ>
–21/360, –14/360,
–7/360, 0/360,
7/360, 14/360, 21/360,
GRAPHIC (*1)
Options
Fine-tunes the left print start
position for continuous forms.
Moves the position left or
right in increments of 1/90
inch (0.28 mm).
Fine-tunes the left print start
position for single sheets.
Moves the position left or
right in increments of
1/90 inch (0.28 mm).
Compensates the line spacing
pitch on the basis of the
spacing error accumulated for
feeding single sheets by10
inches.
Decreases or increases in
increments of 1/360 inch in
total.
Compensates the line spacing
pitch on the basis of the
spacing error accumulated for
feeding single sheets by10
inches.
Decreases or increases in
increments of 1/360 inch in
total.
This option is available only
when paper is being loaded in
the cut sheet feeder.
Description
User's Manual
Advertisement
Table of Contents
