Table of Contents
Advertisement
SETTING UP
2-12
To plug in the power cord:
1. Plug one end of the power cord into the power connector on the
rear of the printer.
2. Plug the other end of the power cord into the power outlet.
Connecting the power cord
3. Make sure that the power cord is securely connected.
4. Turn on the power by pressing the side marked "1" on the power
switch. Within a few seconds, the POWER indicator on the printer
control panel will light, the print head will move to its home position,
and the ONLINE indicator will light (green).
NOTE
If no forms are loaded, the printer may beep and the red PAPER OUT
indicator may light and the ONLINE indicator will not light if the paper
select lever is set backward to the continuous forms position. Move the
paper select lever forward to the single sheet position (as described in the
next section). The PAPER OUT indicator will go out. This condition is a
result of the factory default settings and poses no problem.
User's Manual
Advertisement
Table of Contents
