Procedure - Fujitsu DL 3750+ User Manual

USING SETUP MODE
< < F U N C T I O N > >
SAVE&END MENU1
V-ALMNT
<TEAROFF>
5-48

Procedure

To change the printer configuration options, make sure that continuous forms
paper is loaded and then proceed as follows:
1. Enter setup mode.
Press the TEAR OFF button and the ONLINE button simultane-
ously until the printer beeps. Wait for the printer to stop printing
and check that the following <<FUNCTION>> menu is printed:
MENU2 HARDWRE ADJUST
2. Select the CONFIG function.
Repeatedly press the LOAD button or the LF/FF button to position
the red cursor under CONFIG. Press the MENU button to select
the CONFIG function and print the following <TEAROFF>
options:
MANUAL AUTO
3. Select an option.
Press the LOAD button or the LF/FF button to move the cursor to
either MANUAL or AUTO. Press the MENU button to select the
option and print the <TEARPOS> item. If other items must be
specified, do so now. Otherwise, go to step 4.
4. Exit the CONFIG function.
Press the ONLINE button to exit the CONFIG function and reprint
the <<FUNCTION>> menu.
5. Do either of the following:
• Select another function, or
• Exit setup mode, saving your changes.
For details on other functions, see the other sections in this chapter.
To exit setup mode and save your changes, make sure that the red
cursor is positioned under SAVE & END, then press the MENU
button or the TEAR OFF button.
.
CONFIG DEFAULT LIST SELF-TST HEX-DUMP
User's Manual