Table of Contents
Advertisement
User's Manual
Table 5.6 CONFIG Items and Options (Cont.)
NOTE: Underlined options are the factory defaults.
CONFIG Items
Options
<CONT-PE>
TRACTOR
EDGE
GATHER
ENABLE
DISABLE
CUT-CTL
PRCISIN
SPEED
USING SETUP MODE
Description
Detection of end of continuous forms.
Paper end is detected by the sensor on
the tractor unit.
Paper-end unprinted area:
Continuous forms: About 80 mm
Regardless of paper end, printing
continues near to the edge of paper.
Paper-end unprinted area:
About 4.7 mm for both continu-
ous forms
Setting of ribbon protective control
at a line feed on continuous forms
The protective control is executed.
The protective control is not
executed.
Setting of retracting control at
canceling TEAR OFF of continuous
forms.
The precision-prioritized retracting
control is executed.
It retracts a certain amount of paper
(the top part of the paper which
hangs out from the TOFS), and then
moves back to the position before
TEAR OFF. If TOFS detects paper
end when a certain amount of paper
is retracted, it executes the continu-
ous forms save operation and then
executes the paper loading opera-
tion.
The speed-prioritized retracting
control is executed.
It retracts the paper by the amount
the paper was advanced.
5-45
Advertisement
Table of Contents
