Programming The Control; Enter Installer Programming Mode Without Using Installer Code; Change Installer Code; Select A Language - Honeywell L5200 Series Installation And Setup Manual

After entering the System Programming mode select from the options provided on the First and Second
Installer Programming tools screens as shown in the accompanying figure.
System Programming...
Installer Code
Date Time
Zones
Keys

Enter Installer Programming Mode without using Installer Code

System Standby!
1 : 0 00
January, 1, 2011

Change Installer Code

The factory default Installer Code for the LYNX Touch Control is set to 4-1-1-2.
SCREEN
Installer Code
5000-100-129-V0

Select a Language

Note: This programming field may not be available with the system being installed.
System Programming...
Sounder
Default Config.
Reset Master Code

System Type

Communicator
Comm. Diagnostics
Reporter
5000-100-013-V1
Page 1
SCREEN
1. Select "Installer Code". The current four-digit Installer Code is displayed on the left side
of the screen.
2. Select the "Clear" button, then enter a new four-digit Installer Code on the displayed
keypad. The system will display the new code on the left side of the screen.
3. Select "Done" when you are finished.
4. The system returns to the "System Programming" Screen.
SCREEN
System Settings
Language
Z-Wave
5100-100-060-V0
LYNX Touch Installation and Setup Guide
Sounder
Default Config.
Reset Master Code
1. During the initial system power-up initialization delay
(while "SYSTEM STANDBY!" is displayed), depress the
Home key. Wait for system to terminate the system
initialization delay.
2. Select the "Security" icon.
3. Select the "Arm Stay" icon.
4. Press the "Clear" key on the displayed keypad. A blue
vertical bar is displayed below the "Enter Code".
5.
Enter "00" on the keypad. The system will enter Installer
Programming mode and the Installer Tools Menu will be
displayed.
5200-100-012-V0
ACTION
1. If applicable, select "
options:
Installer Language
2. Select "Installer Language. The system toggles between
"English" and "French".
3. Select the desired language.
4. Select "User Language. The system toggles between
"English" and "French".
5. Select the desired language.
6. Select "Save" when you are finished.
7. A confirmation screen appears. If "Yes" is selected, the
System returns to the second page of the Programming
screen, which will be displayed in the selected language.
- 27 -

Programming the Control

System Programming...
System Settings
Language
Z-Wave
Page 2
ACTION
ACTION
Language
" to display the following
User Language
5100-100-060-V0