Program Keys - Honeywell L5200 Series Installation And Setup Manual

LYNX Touch Installation and Setup Guide
Programming the Control

Program Keys

The following system options are programmed in this section
Option
Key Type
User
Serial Number
Zone
Button Key * - Zn *
* Key number and Zn number are dependent upon the Key Type selected.
Note: If applicable, preprogrammed defaults for the L5200/L7000 Control are shown on the screen unless otherwise noted.
SCREEN
Keys
Key Type
4 Button key
User
Serial Number
0
Zone
49
Select the specific type of key being entered or enrolled
Associates the Key with a specific User
Manually enter key serial number or enroll via RF transmission
Manually enter key zone number (between 140 and 155) or enroll via RF transmission
Associate the selected button with a specific function
1. Select "Keys"
The System displays the following options:
Edit
2. Select "Add New".
3. The following options are displayed (dependent upon the "Key Type" selected):
Key Type
Serial Number
Button Key 1 – Zn 140
Button Key 3 – Zn 142
Button Key 5 – Zn 144
Button Key 7 – Zn 146
Select an option to display the next programming field.
Key Type
Select "Key Type". The system scrolls between the following:
1 Button key
2 Button key
4 Button key
User
Select "User" then select from the following options (or the list of Users that have been
programmed):
Master
Duress
User 4
User 6
Use the down  arrow to scroll to the next page. The system displays options for User 8
through 30 (L5200) or 8 though 46 (L7000).
Note: The Key must be associated with a specific User/User Code in order for it to operate.
Refer to the LYNX Touch User Guide for additional Information regarding User Codes.
Serial Number
When "Serial Number" has been selected "Enter Serial Number or Activate" is displayed. The
transmitter serial number and loop number can be enrolled via RF transmission OR manually.
Enroll via RF Learning To enroll the device using RF Learning mode three transmissions
(open/close) of the device will be required. The initial transmission activates the RF Learning
mode. A second transmission enrolls the serial number and the system beeps two times and
displays "Activate Sensor Again To Confirm". A third transmission will confirm the serial
number. The system beeps three times and returns to the Zone programming Screen.
Enroll Manually
Enter the 7-digit serial number printed on the transmitter using the displayed keypad and
select "Done". The system beeps one time and returns to the Zone programming Screen.
Zone
The system displays the next available key Zone number. Select "Zone" to manually enter a
specific Zone Number on the displayed keypad (140-155). If the desired Zone Number is not
available, the system returns to the previous screen.
Select "Done". The system returns to the previous screen. Repeat the previous step to enter
another Zone Number.
Function
ACTION
Add New Delete
User
Zone
Button Key 2 – Zn 141
Button Key 4 – Zn 143
Button Key 6 – Zn 145
Button Key 8 – Zn 147
6 Button key
8 Button key
Guest
User 3
User 5
User 7
- 38 -