Installing The L5100-Wifi Module; Installing The L5100-Zwave Module - Honeywell L5200 Series Installation And Setup Manual

Hide thumbs Also See for L5200 Series:
Table of Contents

Advertisement

Installing/Configuring Communication & Home Automation Modules
TO ILP5
RJ45 RECEPTACLE
LYNX TOUCH
ALTERNATE INSTALLATION
CONNECTOR
BOARD
CONNECTOR BOARD
SCREW
(3)

Installing the L5100-WiFi module

Do not install the L5100-WiFi if the ILP5 Ethernet communications module is being installed.
1.
Install the L5100-WiFi into the LYNX Touch control front case as shown below. Ensure that the receptacle is properly
seated into the edge connector on the right (speaker) side of the control's circuit board.
2.
Enable the L5100-WiFi module, configure alarm reporting and module supervision and register the device. Refer to the
"Program the Communications Module" and "Communications Diagnostics" sections.
The communications module must be registered with AlarmNet before downloading or alarm reporting can
take place.
Installing the L5100-ZWAVE Home Automation module
1.
Enable the L5100-ZWAVE module. Refer to the "Program the Z-Wave Module".
2.
Install the L5100-ZWAVE into the LYNX Touch control front case as shown below. Ensure that the receptacle is properly
seated into the edge connector on the left (TELCO terminal) side of the control's circuit board.
ETHERNET CABLE
ILP5 SPACER
RJ45
RECEPTACLE
ROTATED
TIE
180
WRAP
(1)
TIE
WRAP
POINT
ILP5
RECEPTACLE
LYNX TOUCH
L7000
L7000 IP Communications Module Installation
LYNX Touch Installation and Setup Guide
REMOVE ILP5
KNOCKOUT
- 15 -
REMOVE ILP5
SPACER
7000-100-014-V0

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Lynx touch l7000 series

Table of Contents