Communications Diagnostics; Communications Status; Ethernet Information; Gsm Information - Honeywell L5200 Series Installation And Setup Manual

Hide thumbs Also See for L5200 Series:
Table of Contents

Advertisement

Communications Status – The system provides a status of the IP or GSM communications paths and
performs a self-test of the AES encryption algorithm as follows:
Message
GSM:
OR
IP:
Encryption:
AlarmNet Registration:
Ethernet Information – Displays IP information, if the IP communication path is enabled.
Physical Link:
DHCP:
NIC IP Address:
Subnet Mask:
Gateway IP Address:
DNS Server IP Address:
Message
Physical Link
DHCP
GSM Information – Displays GSM information if GSM communication path is enabled.
Status
GSM Registered
GSM Not Registered
Searching For Coverage!
SIM Error!
Cell Registration: SIM Not Active
Cell Registration: Not Registered
RSSI Note:
Primary Site Signal strength is displayed by a series of 1 to 5 stars (* weak to ***** strong) or "Not Present" if there is no
signal. To ensure a reliable installation at least 2 (**) stars should consistently be present. Secondary site presence is
indicated by "Present" or "Not Present".
OK
Normal; No fault. (IP or GSM)
Fault Reported!
No network connectivity and fault time has expired. (IP or GSM)
Not Connected
No network connectivity over IP and fault time has NOT yet expired.
Not Registered!
No network connectivity over GSM and fault time has NOT yet expired.
No Physical Link
No network connectivity over IP and fault time is set to 0.
AES Passed!
Test successful.
AES Failed!
Test failed.
No Encryption!
No encryption algorithm set.
Registered
Communication Device is Registered with AlarmNet.
Not Registered
Communication Device is not Registered with AlarmNet.
Confirms the physical link connection to the internet and the connections speed.
DHCP (Dynamic Host Configuration Protocol) indicates server is performing satisfactorily.
Displays the IP address assigned to this device
Displays the 32-bit address mask used to indicate the portion (bits) of the IP address that is being
used for the subnet address.
Displays the IP address assigned to the Gateway.
Displays the IP address assigned to the DNS (Domain Name System) server.
10 Mbps or 100 Mbps
Link speed of physical connection
Bad
No physical connection
OK
DHCP address resolved
Bad
DHCP address not resolved
Off
DHCP disabled
Message
Cell Registration:
Primary RSSI:
GPRS: (2G Only)
(Always available in 3G/4G)
Country:
Network:
Cell: (2G only)
Cell: (3G/4G only)
Base Station: (2G Only)
Pri Sync Code (3G/4G Only)
Channel:
Second Site RSSI:
LYNX Touch Installation and Setup Guide
Home 2G
Registered Home with 2G Service
Home 3G
Registered Home with 3G/4G Service
Roaming
Registered Roaming
(See RSSI
Primary Site RSSI level signal strength
Note below)
(1 to 5 stars or "Not Present" will be displayed)
Yes
GPRS Service availability
No
GPRS is not available
xxx
Country Code
xxx
Network Code
LAC
xxxxx
Local Area Code
xxxx
Base Station ID
xxxxxx
Base Station ID
xx
Base Station Antenna Sector
xxx
Primary Sync Code
xxxx
Control Channel in use
Secondary Site RSSI level availability
(See RSSI
Note below)
("Present" OR "Not Present" will be displayed)
Searching for cell network.
No SIM card present or SIM card faulty
SIM is not activated
Not registered with cell network
- 51 -
Programming the Control

Communications Diagnostics

Meaning
Meaning
Meaning

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Lynx touch l7000 series

Table of Contents