Programming The Control Panel; Quick Programming (Vip Mode) - Honeywell TUXWIFIS Installation And Setup Manual

About the System (cont'd)

Programming the Control Panel

The keypad is not fully operational unless its address in the control panel has been enabled (set as an
alpha console) AUI type device, and assigned to a partition (where applicable). For a list of compatible
alarm systems, refer to the "Compatibility Table" in Section 1 of this document for the quantity of
keypads that may be used and the required control panel software revision level.
We recommend that you use either a standard alpha keypad or the keypad in Console Emulation Mode
when programming the control panel. When in the Console Mode, the keypad emulates an alpha
keypad and the programming of the panel is performed following the procedures provided in your
panel's Installation and Setup Guide.
NOTE: When programming your control panel, if you change the zone types for your emergency zones
you may disable the emergency buttons in the keypad. The emergency buttons in the keypad are active
for zone types 06 (Silent Panic Button), and 07 (Panic Button), 08 (Medical Button), and 09 (Fire
Button). Additionally, the Medical button is also compatible with a zone type 15 (24-Hour Medical) for
panels that contain this zone type.
On residential control panels (VISTA-20P or equivalent):
Up to four keypads may be used (addresses 1, 2, 5 and 6). Addresses 1 and 2 (in field *189) are enabled
by default. If the defaults have been changed, enable these addresses (in field *189) using an alpha-
keypad and the Data Field Programming procedures located in the panel Installation and Setup Guide.
On commercial control panels (VISTA-128BP, VISTA-128FBP, or equivalent):
Addresses 1-2, and 3-30 may be used for older controls under Rev. 10 supporting 3 AUI's, see Important
Note below. Addresses 1-30 may be used for commercial Turbo controls Rev. 10 and higher supporting 6
AUI's. These addresses in the control panel are normally not defaulted for AUI type devices. To enable
the addresses you are using for keypads, use an alpha-keypad and follow the procedures for "Device
Programming" in your control panel "Programming Guide."
Important Note: If multiple keypads are being used, they must be set to addresses 1, 2, and X (where
X equals any address from 3 through 30). Only one AUI type device may be assigned to an address from
3 through 30 on commercial control panels.
The Keypad should not be assigned as a Master Console. If the keypad is assigned as a Master Console,
partitions must be controlled from the Partition screen or using the Console Emulation Mode.

Quick Programming (VIP Mode)

Tuxedo supports Quick Programming VIP (Vista ® Intelligent Programming) mode when used with a
control panel that supports this feature. Check the control's manual to check if it supports this function
and for further instructions.
To access Quick Programming mode, while in Normal Mode, press the Setup > System
icons.
Select the Quick Programming button: the screen displays a "Confirmation" message:
"Not every
security panel supports quick programming. Check the panels documentation to make sure it supports quick
programming. Choose Abort if the panel does not support it or Continue to enter quick programming. Choosing
Continue on unsupported panels may result in this device resetting. Continue or Abort.
Select Continue, and then enter an authorized code. An "Information" message is displayed:
"Panel is
entering programming mode, please wait..."
Follow the prompts to program the control panel.
8