Follow Me" Reminder Feature (L5200/L5200Cn Only); Remote Phone Control Feature (L5200/L5200Cn Only) - Honeywell L5200 Series Installation And Setup Manual

"Follow Me" Reminder Feature (L5200/L5200CN Only)

The "Follow Me" feature allows the user to schedule a time driven message. When activated, the system will
dial the Phone 1 and/or the Phone 2 telephone numbers, which are programmed as Follow Me Phone 1 and
Follow Me Phone 2 respectively by the installer (in the Reporter Programming section), and deliver a
recorded message. The LYNX Touch will immediately begin transmitting the voice message and will repeat
the message for 45 seconds. If the message has timed out, the system will redial the programmed number a
maximum of seven additional times or until it is acknowledged. Selecting "OK" when the confirmation
screen is displayed on the LYNX Touch will terminate both the "Follow Me" reminder and the local reminder
announcements.
Notes: (1) This feature is only supported if it has been programmed.
(2) The follow me reminder will be terminated if any other event requires the system to dial out, however, delivery of
the local schedule reminder message will continue.
(3) If a Central Station report must be sent, the "Follow Me" Reminder message will be suspended. Once the PSTN
line is available the session will be resumed and the control will again make up to 8 delivery attempts.

Remote Phone Control Feature (L5200/L5200CN Only)

The remote phone control feature, which must be enabled, allows the user to access the security system from
any off-site touch-tone telephone. The control will pick up the incoming call, based on the specified ring
count, and will announce "SYSTEM ENTER CODE" every three seconds for the next nine seconds. During
this period the panel will wait for a valid User Code to be entered. If a valid User Code is not entered or the
nine second period expires a modem tone will be generated for remote programming (Compass
Downloading). If a valid User Code has been entered, the control will announce the current system status
and/or beeping sounds. Refer to the User Guide for additional information regarding this feature.
LYNX Touch Installation and Setup Guide
- 63 -
System Operation