Loading Factory Defaults; Select A Default Configuration; Exiting Programming Mode - Honeywell L5200 Series Installation And Setup Manual

Hide thumbs Also See for L5200 Series:
Table of Contents

Advertisement

LYNX Touch Installation and Setup Guide
Mechanics of Programming

Loading Factory Defaults

To load the factory defaults, enter the Installer Programming Mode and advance to second page of the
System Programming and refer to following procedure. Refer to the Programming Default Values section of
this manual to view the Default Values.
If a default configuration is loaded, any data that has already been programmed into the system will be
changed according to the default configuration selected!

Select a Default Configuration

SCREEN
System Programming...
Sounder
Default Config.
Reset Master Code
Exiting Program Mode
1. Select the "
" key to exit the current screen. The system returns to the previous screen.
2. Select the "
" key as required until system displays a Confirmation screen.
3. Select "Yes" to allow the installer to re-enter Programming mode or "No" to prevent re-entry.
4. Select the "
" key again to return to the Security Screen OR depress the Home button to return to the
Home Screen.
System Settings
Language
Z-Wave
5100-100-060-V0
1. Select "Default Configuration" to display the following options:
Default Config 1
Default Config 3
Default Downloader
Note: For a list of the pre-programmed defaults refer to the
Default Values section.
2. Select the desired Default Configuration.
3. A Confirmation screen is displayed.
4. If "Yes" is selected, the System beeps three times and returns
to the Default option screen.
5. If "No" is selected, the System returns to the Default option
screen.
- 24 -
ACTION
Default Config 2
Default Config 4

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Lynx touch l7000 series

Table of Contents