LYNX Touch Installation and Setup Guide
Programming the Control
After entering the System Programming mode select from the options provided on the First and Second
Installer Programming tools screens as shown in the accompanying figure.
System Programming...
Installer Code
Date Time
Zones
Keys
Enter Installer Programming Mode without using Installer Code
SYSTEM STANDBY!
Disarm
Delay
10:18 AM June 8, 2010
Change Installer Code
The factory default Installer Code for the LYNX Touch Control is set to 4-1-1-2.
SCREEN
Installer Code
5000-100-129-V0
Select a Language
Note: This programming field may not be available with the system being installed.
System Programming...
Sounder
Default Config.
Reset Master Code
System Type
Communicator
Comm. Diagnostics
Reporter
5000-100-013-V1
Page 1
SCREEN
72
More
1.
Select "Installer Code". The current four-digit Installer Code is displayed on the left side
of the screen.
2. Select the "Clear" button, then enter a new four-digit Installer Code on the displayed
keypad. The system will display the new code on the left side of the screen.
3. Select "Done" when you are finished.
4.
The system returns to the "System Programming" Screen.
SCREEN
System Settings
Language
Z-Wave
5100-100-060-V0
Sounder
Default Config.
Reset Master Code
1.
During the initial system power-up initialization delay
(while "SYSTEM STANDBY!" is displayed), depress the
OFF key. Wait for system to terminate the system
initialization delay.
2.
Depress the OFF key again. The touchscreen displays
a keypad.
3.
Press the "Clear" key. A blue vertical bar is displayed
below the "Enter Code".
4.
Enter "00" on the keypad. The system will enter Installer
Programming mode and the Installer Tools Menu will be
displayed.
5000-100-200-V2
ACTION
1. If applicable, select "
options:
Installer Language
2. Select "Installer Language. The system toggles between
"English" and "French".
3. Select the desired language.
4. Select "User Language. The system toggles between
"English" and "French".
5. Select the desired language.
6. Select "Save" when you are finished.
7. A confirmation screen appears. If "Yes" is selected, the
System returns to the second page of the Programming
screen, which will be displayed in the selected language.
- 22 -
System Programming...
System Settings
Language
Z-Wave
Page 2
ACTION
ACTION
Language
" to display the following
User Language
5100-100-060-V0