Transmission Assembly; Remove And Install - Taylor-Dunn B0-254-48 Operation, T Roubleshooting And Replacement Parts Manual

Maintenance, Service, and Repair

TRANSMISSION ASSEMBLY

Remove and Install

6. Release the park brake.
7. Remove the park brake cables from the spring axle
mounting brackets and brake arms.
8. Disconnect the wiring from the motor.
9. Disconnect the hydraulic brake lines from the left and right
brake bodies.
10. Remove the u-bolts holding the leaf springs to the
frame as shown in the illustration to the right. Do
not remove the u-bolts on the axle housing.
11. Remove the lower shock mounting bolts and the
front spring mounting bolts.
12. Raise the rear of the vehicle, lifting the frame up
and off of the drive assembly. Support the rear of
the vehicle with jack stands.
13. Reinstall the drive in reverse order.
NOTE: Lubricate the transmission input shaft with a small amout
of 94-421-34 grease.
14. Bleed the brake system. Refer to
System
for information regarding bleeding the brakes.
15. Set the park brake.
16. Lower the vehicle and reconnect the main positive and
negative cables at the batteries.
18. Remove the blocks from the wheels, release the park brake
and test drive the vehicle.
1. Make sure the key-switch is in the "OFF" position, then remove
the key.
2. Place the forward-reverse switch in the center "OFF" position.
3. Set the park brake.
4. Place blocks under the front wheels to prevent vehicle movement.
5. Disconnect the main positive and negative cables at the batteries.
Always use a lifting strap, hoist, and jack stands, of adequate capacity
to lift and support the vehicle. Failure to use lifting and support devices
of rated load capacity may result in severe bodily injury.
Bleed the Brake
Transmission Page 8
Transmission input shaft