Installation; Steering Component Service - Taylor-Dunn B0-254-48 Operation, T Roubleshooting And Replacement Parts Manual

Installation

6. Raise the front of the vehicle and support with jack stands.
7. Install the front axle in reverse order of removal.
NOTE: Use all new cotter pins.
NOTE: Refer to the
NOTE: Refer to
8. Realign the front wheels. Refer to
regarding realigning the front wheels.
9. If equipped with front brakes, bleed the brakes. Refer to
regarding bleeding the brakes.
10. Lower the vehicle.
11. Reconnect the main positive and negative cables at the batteries.
12. Remove the blocks from behind the wheels.
13. Release the park brake and test drive the vehicle.
Maintenance, Service, and Repair
1. Make sure the key-switch is in the "OFF" position, then remove
the key.
2. Place the forward-reverse switch in the center "OFF" position.
3. Set the park brake.
4. Place blocks under the rear wheels to prevent vehicle movement.
5. Disconnect the main positive and negative cables at the batteries.
Always use a lifting strap, hoist, and jack stands, of adequate capacity
to lift and support the vehicle. Failure to use lifting and support devices
of rated load capacity may result in severe bodily injury.
Replacing the Ball Joints
regarding the installing the ball joints or rod ends.
Tires and Wheels
removing the front wheels.

Steering Component Service

Front Axle
section for information
section for information regarding
Brake Service
R
Page 5
section for information
section for information