Inspection - Taylor-Dunn B0-254-48 Operation, T Roubleshooting And Replacement Parts Manual

Maintenance, Service, and Repair

Inspection:

Note: There are no repairable parts in this assembly. The parts must be
1. Measure the free length of the five springs. Minimum length =0.713"
2. Inspect the splines on the hub and the friction plate for damage.
3. Inspect the inner contact plate and the outer housing where they come into contact with the
friction plate for wear or damage.
4. Inspect the three dowel pins and their corresponding
holes in the inner contact plate. The dowel pins
should be straight and the holes should be round.
5. Inspect the bearing for excessive play or roughness
when rotated.
6. Inspect the contact surfaces of the magnet and inner
contact plate for damage and flatness.
Electric motor brake exploded
replaced if any damage or wear is found.
Brakes Page 14