Repair The Master Cylinder - Taylor-Dunn B0-254-48 Operation, T Roubleshooting And Replacement Parts Manual

REPAIR THE MASTER CYLINDER

NOTE: Hydraulic brake system components must be kept clean. Make
Remove the master cylinder from the vehicle. See Replace the Master Cylinder section .
Drain all fluid from the master cylinder and discard.
Remove the rubber boot.
Depress the plunger and remove the plunger spring clip retainer.
Pull the plunger and all seals out of the master cylinder bore.
Thoroughly clean, inspect and replace parts as required.
If any damage is found in the bore of the master cylinder then it must be replaced.
Lubricate all parts with clean brake fluid from a sealed container.
Reassemble in reverse order.
If the master cylinder is not to be immediately installed onto a vehicle, plug the brake line fitting hole to
prevent any contaminates from entering the master cylinder.
Maintenance, Service, and Repair
sure your work area is free from dirt and debris and will contain
any brake fluid spills.
Brakes Page 25