Transmission Assembly; Remove And Install - Taylor-Dunn C0-014-32 Operation, T Roubleshooting And Replacement Parts Manual

Maintenance, Service, and Repair

TRANSMISSION ASSEMBLY

Remove and Install

1. Make sure the key-switch is in the "OFF"
position, then remove the key.
2. Place the forward-reverse switch in the
center "OFF" position.
3. Set the park brake.
4. Place blocks under the front wheels to
prevent vehicle movement.
5. Disconnect the main positive and
negative cables at the batteries.
6. If equipped with a built in charger, remove the
charger.
7. Remove the motor wires.
8. Disconnect the brake cable from the brake arm at
the brake band.
9. Remove the four nuts from the bolts holding the
transmission assembly to the frame. DO NOT
remove the bolts at this time.
10. Place two jack stands under the front bumper. They
should be located at each corner of the frame (see
illustration).
Always use a lifting strap, hoist, and jack
stands, of adequate capacity to lift and
support the vehicle. Failure to use lifting
and support devices of rated load capacity
may result in severe bodily injury.
11. Lift the rear of the vehicle just enough to allow the
removal of the transmission mounting bolts and
remove the bolts.
12. Raise the rear of the vehicle high enough to roll
the transmission out from under the vehicle and
support the rear of the vehicle with jack stands.
13. Install in reverse order.
14. Check brake adjustment and adjust as needed.
Adjust the Brakes
Refer to
Service
section for information regarding
adjusting the brakes.
15. Reconnect the main positive and negative at the
batteries, remove the blocks from the wheels, and
test drive.
F2/F3 Transmission
Page 6
Brake
in the
DO NOT place jack
stands where the
bumper is curved.